I have a Telemechanique PLC with Analog and digital I/O, my question is regarding the analog inputs. Two of my analog inputs are coming from effector pressure sensors PN2224, 0 - 145 psi = 4-20mA. My problem is on the PLC input card of the tele processor, I am getting different analog...
Hello, I am a Plant Engineer at a Factory in which money is very tight ( like everywhere else ha ha) My question is regarding lighting. Many areas of our facility have Flourescent F34 T12 Philips Alto 4 bulb fixtures with older Magnetic Ballasts in them. As a controlled test our...
I have recently installed 2 600 amp bus plugs on some 480VAC 1600 amp bus duct. Each of them are feeding chillers which draw approximately 450 - 500 amps on an ongoing basis. Therefore, out of concern, I infrared checked each bus plug with a Flir camera from the production floor...
At my facility I have roof top substations and which some of them I have emergency back up nat gas generators. The generators provide power to 277 Volt Metal Halide Lighting for the production floor and also 277 v flourescent T8 lights with electronic ballasts in the rooftop substation itself...
