Recent content by sgms

Does Anyone know how to convert hysys case from new version to old version, say from hysys aspen v 7 to hysys v 3.2 because I only have hysys 3.2 running in my PC

Thanks everyone

we have bad experience with volumetric measurement, then we decide to have mass flowmeter, also the piping for meter run is not suitable for DP or other type, even with utilizing the straightener. what the testing shall be done and what certificate that required for this purpouse?

Thanks for reply, Recently we met the supplier that able to supply 10" coriolis mass flowmeter. The pipe run is not suitable for DP or turbine meter installation, also the flow have to be measure by mass (ton/hr). The fluid is methanol 99.95% grade. Approval and certification required for this...

Does anyone can help me how to create rquisition for custody flowmeter (mass flow)?

Does anyone can help me! I have to spesify the requisition for generator that fueled with gas (gas turbine) fo 3 MW 6.6 kV 50 Hz

The metal sprayed layer damage, eaten away. One of the opinion is due to liquid carry over from separator upstream.

I work in methanol plant, we have problem with abradable seal. Almost every shutdown we have to change that seal. The seal is sprayed metal into the balance drum. Does any body has experience with similar problem..? thanks, sgms

Does any one know what the difference between CuNi30Fe and CuNi30FeMn?. What exactly improve. This is the tube of sea water cooler for interstage cooling. Thanks, sgms

We seal level gage that connected to steam drum (saturated high pressure steam)

We experience with leakage on gasket for HP Steam (115 barG). Does any body know what suitable for this application. We have tried kligrite (wit wire) and graphite but not sucesfull

We did to improve the V/L separation by the latest spiraflow, but we don't really succesfull. We have another abradable seal damage. Might by the sugestion form imok2 will work. we will work out on that proposal or you have in your hand..? thanks

I want to cool methanol gas-liquid mixture after separator at 40 DegC to about 10 degC. The duty is about 15 GJ/h. Does any body has idea how to do the methanol further cooling. The reason way I want to cool are: 1. To remove as much as possible liquid carry over into downstram compressor (we...