Toost is correct, once you finish the sketch in the drafting, the symbol should go away. I dislike how these dimensions behave so differently in the drafting application vs the older sketcher. But they should go away once you finish the sketch and pan around.
If the curves are already there, you could use N sided surface. Or you could also use Fill surface also. A couple other options if the curves already exist.
You will need to turn it to a PMI dimension, then I think you can. If you right click on the dimension, turn it to PMI. Then you can process this down into your 2D drawings. There will be some switches in your 2d drawing that you need click on. Double click your 2D drawing border, then go to...
Exploded Views is for ISO assembly type drawings, This needs to be done at the drawing level.
Arrangements are for showing different assembly orientations or different options to an assembly.
For example, imagine an air cylinder. In one arrangement, the cylinder is retracted, and in the other...
We prefer to use arrangements a lot, especially for exploded views.
We have many arrangements in our assemblies so this method works well for us. For what it is worth.
I do not think you will find the information in Books. There is Xcelerator training. Link Below.
The help documents, also work well.
There are a ton of questions that have been answered here and in the PLM forums.
I would start searching and doing youtube searches. The Information is out...
The 3DPDF Measurement is not very user-friendly. A couple of small measurements I took, seemed to be consistent with the 3D model. 3D PDF can only go out to 6 decimal places. The PDF and cad matched out to 6 decimal places. For what it is worth. These are simple measurements like a diameter...
"For your 3D PDF, is there a way to toggle between Model Views? Usually, PMI is placed into different model views. In NX, this seems to work well. Is there a way to change or export all of your model views without altering any settings during the 3D PDF export? Just some random thoughts."
"@greenimi Yes, I can take measurements with the 3DPDF using Acrobat, I do not know about the free Adobe Reader. Siemens uses a program called JT2GO, which allows for measurements and offers a much more robust user interface when using 3D PMI.
I have not had much luck with the highlighting of...
Recently, in NX2306 and NX2406, we have experienced random pauses when exiting dialog boxes. (The pause is about 30 seconds) This issue occurs approximately 20% of the time, with the dialog box exiting immediately the other 80%. While this problem is most noticeable with the measurement command...
