Recent content by RylEnfield

Hi there no didnt help ,,,I travel through but couldnt find anything , strangely I can draw the worm ( helix lisp ) but and the worm gear as a straight tooth ie not at an angle to its ( the shaft) axis but I need to draw the worm gear teeth at an 4 deg angle to ist axis, my plan was to revolve...

Hi there Not to sure on how to proceed on theis I have a worm gear with a 4 deg helix ( actually not a spring like helix) Just the 2 end faces are offset from each other by 4 deg in the z plane Sort of like twisting each end Its a shaft with the gear in the middle and the teeth of the gear...

will do ......tack that on the the RT =1/UT have found I think a place which list fouling co eficients So Im on the right track then Stephen

Hello all Sorry about this always seem to be asking , a bit one sided on my part .I have trawled through the achives , but no help hence the post I have to agree with one post, for a re invented wheel . there is precious little info out there ! anyway I need to size a small cross flow heat...

yes it is a 500 bullet !! but my councillor said I would get over this Phase ....The wife has given up ...and I havent seen the dog for a few days ... Thanks for your reply ...it was the oscilating load and the crank position i was worried about, I modeled those rocker block to find out how...

Hello there the flywheel crank pin of my single cylinder engine, has a floating plain bush ie there is a solid bronze bush between the crank pin and conrod ....not in babit type as per car, modern bike... But a large lump of bronze like a polo mint ( would be easier to draw a picture .....)...

That was on my list but I am worried about the heat and losss of Uts , the heat in the current unit can get to around 300 deg c , as the plates show signs of blueing... due to slippage So we had do tuck a few more plates in there to avoid slip ... Thank you kindly for your help Stephen

Hi there is for clutch plates in a friction disc multi plate clutch, oil cooled the chain just dipps into the oil but the plates are not submersed Spring pressure 350 psi total kind regards for a great answer stephen

Dear all I am in the middle of selecting either a brass or bronze for a pressure /wear situation the pressure is around 350 Lb and the relative movement between the two is for a very short tine I am wondering what the roles of Zn and Sn play when added for example if I choose a bronze with...

Thank for that I will ta

Hi there Very sorry for this , I posted this already butfor some reason could not open the reply someone sent. I have a single cylinder motorcycle engine . What I want to do is get an estimate of the frequency and loads ..the operating range is between 2000 and 4000 rpm for the frequency I...