I wasn't going to reply to this thread again, because I knew this wasn't the place for it. However, after reading Solid7 latest thread, I just had to chime back in.
This will be my last reply and there will be nothing further directed towards another person on this forum.
I'm not trying to...
Thanks for all the help.
I'm just a little curious as to why Solid7 always has to jump all over posts that he may not agree him. I've read to many replies where he had a negative reply to a question. The fact of the matter is it doesn't really matter what I am doing, only wheather or not the...
I have a solid model that I would like to split (Or what ever Catia calls it) without removing any material.
I am trying to take a solid shape and split the solid into two separate halves, so I can apply draft.
The split command removes part of the solid. I would like to select a plane the...
Does Catia have the ability to calculate / Measure fluid volume in an assembly?
A have a hydraulic cylinder assembly that I would like to measure the fuid volume.
I have a model, which has one surface which appears to have the surface set to a transparency of 0 (Zero). I've selected the Partbody from the specification tree and set the transparency in properties to 255 (Full transparency), but the surface still won't show transparent. I then selected the...
I have a drawing with a Breakout view, but no longer need the breakout. How do I delete the breakout from the view. I don't see anything listed in the specification tree or the properties of the parent view.
Tank you.
Can the available values be edited once created?
I have created numerous parameters with multiple values, but would like to go back and add to the available list.
Thanks,
I have a set of notes on my drawings, but would like to add some attribute linked text within the notes...like a part number, material, etc.
Do I need to create a special type of note or can I simply add a link within the text note, where I want that attribute link text to be inserted?
Can this...
Got it!
Its a little confusing, but you need a point (Isolated), a line through the point and normal to a surface, an axis system and then a "positioned" sketch for the groove (Using the axis system, point and line).
Ryan
I am trying to create revolved powercopies for different style ports.
I looked at the ones on CATBlog, but am unable to follow how they were created...or understand what was done.
I am creating a solid block and then creating a revolved port (Material removal). I then following the steps to...
