Thanks EdStainless for the response
These forgings are for custom body flanges and other than the pressure vessel's designer's tolerance (typically the TEMA tolerance) on the finished machined body flanges; there isn't a ASME code standard tolerance. Also the forged rings are typically rough...
Hello,
Question: For a physical calibration standard/block for angle beam UT, how much of a change in thickness is allowed between the forging being UT inspected and the calibration standard/block?
We often buy forged rings that are then machined into body flanges.
One of out suppliers only...
Thanks EdStainless for the feedback! Interesting how you heat treat the knives you make!
My plan is to change material for the next batch we make. I'm still evaluating the options.
A Fan of EngTips, share the knowledge
BiPolarMoment, with the parts being relatively small, it makes it more challenging to case harden. Like mfgenggear suggested, through harden to 40 HRC and then induction harden the case so the tips are 60-65 HRC. That is interesting and worth considering; lots of steps and might not be very...
mfgenggear, thanks for the link to the data sheet!
From M2 tool steel data sheets, striving for 62 to 64 HRC seems to be the sweet spot for trying to optimize both high hardness and high impact strength.
With how we use the parts, they fail in brittle fracture, not yielding in compression...
Thanks mfgenggear for the response!
The parts are small, made from 1.38" OD to 1.588" OD annealed round bar into a triangular shape (chisel). We make a couples different sizes of wedges.
They are double tempered, then hardness tested, if too hard (above 64 HRC) then a third temper is done...
Requesting feedback on tool steel material recommendation for nut splitter wedge. Used to split seized nuts, typically A-194 2H [Nuts have max hardness of 38 HRC (327 Brinell)], nut batches are proof load tested based on proof stress of 175 ksi.
In the past, the trades men at the company...
What material is used for the large rolling shafts that are used to roll plate in steel plate mills?
What material is used for the large rolling shafts that are used to roll plate into shell courses or cones?
Is a different material used in hot rolling (steel plate mill) than in cold rolling...
Thank you in advance for your time and potential responses
At the shop they repair equipment used at the facility. In this case it is a fork lift. There is pivot point (pin with a bushing), that eventually develops a flat spot (especially on the ones from the factory which are mild steel)...
Hello,
Thank you all for your responses to date.
The main reason for testing is to determine which wells are still economically viable to keep pumping. The company has strategically position itself to be a low cost producer in a certain region.
Yes, the aim is to measure 0.1% by volume of...
Hello,
I'm not a petroleum engineer, please be understanding of my limit knowledge
My desire is to determine the best test method for measuring oil cut to an accuracy precision of ±0.1% volume. Test needs to be judged from economic perspective too. Needs to be practical and economical...
Many oil and gas plant owners and operators have their own material specifications that relate to steel plate exposed to wet H2S service.
Often these client specification are partly based on the following:
- NACE MR0175/ISO 15156-1:2015 Petroleum, petrochemical, and natural gas industries -...
