Hi Roy,
Many thanks for your help but this was what I was already doing (I should have said), its still a chore though with nearly 450 parts to modify even with a Mapkey. I will have to investigate the Pro/batch approach.
Regards
Hi All,
Can anyone advise if there is a method in order to change the part accuracies of all the components in an assembly without having to open each part file seperately and manually change it?
I have to change the part accuracies on 48 parts in each of 9 assemblies (all different...
I would create it as an assembly but if you have Pro/Process for Assemblies you can create Components States in which you can choose which components you want to blank or show.
Hi, I could'nt access your model either so I built it from scratch in version 2000i with guessed dimensions and had no problems with it meshing in Pro/FEM with the default accuracy of 0.0012, I think you may not be referencing the cylinder properly when you are sketching the angle irons, even...
I use Pro/E for modelling and Pro/FEM for Mesh construction. Pro/FEM allows good control over the mesh at local points with hard points and curves for loading. Models can be meshed using solids or shells and the mesh size controlled locally or globally. Material can also be setup in Pro/FEM...
