Autocol,
Thanks, real close too the solution my reps came up with, only I do it all on the base sketch making the right triangle out of construction geometry.
I know I should’a posted the answer as soon as I got it, but it was one of those got the answer and ran with it.
Regardless, yours...
I think I tried every possible tangent combination possible. I had limited success with putting a chamfer on the hole/cylinder (tangent of a cone to a ball), but if the radius of the ball greatly exceeds the Dia of the hole the ball hovers above the pane it should be dropping into.
I also tried...
I’m new to Inventor, just got Version 6.
I am having trouble with a constraint problem.
I work allot with lenses, so a sphere locating on a hollow cylinder (a spacer) is a common occurrence, to properly space two lenses. I have not been able to constrain this geometry.
I assume the same...
