...BTW, I tried to extract the desired surface area by
using the intersect surface command to cut away the portion
of the surface I wanted to remain. However, I am using some
tight fillets in the polyline which Mech Desktop doesn't
seem to like.
Thanks again.
NancyL
Hi,
I created a UV lofted surface with spline U's and straight
wire V's. No problem. Next, I need to create a 'cut-out'
of that surface that is irregularly shaped using splines,
fillets and line wires. I can't use 'amplane' because I
need the surface to undulating. I can't use UV loft with...
