Please share the European steel manufacturer who can manufacture A516 70 plate with following;
As rolled
3 mm thick
Normalized
Impact tested
Regards,
Ijaz
Dear all,
Please share detailed calculations for tubesheet of DEU exchanger based on AD Markblatter code.
This is required to understand the philosophy as i am not using this code frequently.
Regards,
Ijaz
Dear all,
Please share detailed calculations for tubesheet of DEU exchanger based on AD Markblatter code.
This is required to understand the philosophy as i am not using this code frequently.
Regatds,
Ijaz
Dear Sir,
Para 207-3.5 of ASME PCC 2-2018 states that "Plug/slot welds may be designed to take up to 30% of the patch plate load.".
Please explain how "Patch plate load" shall be calculated as i could not find the formula to determine patch plate load in ASME PCC 2.
Regards,
Ijaz
We want to design a blank for 6inch carbon steel (API 5L B) piping. Design pressure is 25kg/cm2g and design temp are 74 deg C and minus 10 deg C.
Flange is 6"-300# A105 WN RF and gasket id is 168.3mm.
Available material is A285C 15 mm thk plate. For given design conditions, min thickness of...
We want to design a blank for 6inch carbon steel (API 5L B) piping. Design pressure is 25kg/cm2g and design temp are 74 deg C and minus 10 deg C.
Flange is 6"-300# A105 WN RF and gasket id is 168.3mm.
Available material is A285C 15 mm thk plate. For given design conditions, min thickness of...
Thank you for your responses.
@MJCronin
We try to find quote of 3mm thk A 537 Cl1 plates but no vendor gave offer.
@mk3223
It is out of service for 25 years. Now we want to take in operation.
Corrosion is mainly due to CUI.
1. Whats wrong to use SS316 on CS roof other than galvanic corrosion...
Dear All,
We have an Ammonia storage tank designed on API 620 R. Material of construction for roof, shell and bottom is ASTM A 573 Cl.1 (CS). Min metal design temperature is minus (-)45 deg C and operating temperature is minus (-)33 deg C.
Inspection of roof is done and it is badly corroded...
A tank (designed on API 620 Appendix R) has roof with supporting structure as shown in attachment.
In appendix F of API 620, there is sample calculation of self supporting roof but no calculation available for roof with supporting structure.
Please share reference/guidelines of calculation to be...
We have a tank with 8 shell courses (SCs). 04 SCs (from bottom to top) are of different thicknesses (i.e. 11.3, 10.1, 8.8 and 7.6mm) and thickness of remaining top 04 SCs is 7.4 mm.
My questions is:
In API 650 Annex-E para E.6.2.2.2, maximum longitudinal shell compression stress (Sc) shall be...
Dear Sir,
1" NPT threaded carbon steel elbows (3000#) and piping are installed at downstream of control valve drain. Service is hot compressed air (P = 7.5 bar and Temp = 350 deg C).
Control valve is passing.
Now it is required to install NPT valve at open end (drain end) of piping to contain...
