Are there any sort of "inspection" type opportunities within your general location where your experience would be valuable? I know several individuals who have quit their "career" and gone onto inspecting for other companies doing similar work. They seem to be pretty stress free positions, and...
My only comment is a "when in Rome" type thing. Take a look at what the construction guys are wearing, this will give you an idea for what works for your particular job site. They are working in the conditions all the time so they've usually found something that works.
On a recent project it...
Just because a pipeline is X years old doesn't mean that it is in good or bad condition. There are lines that are 80+ years old that are still in service with no problem, and there are also lines that haven't lasted 10-20 years before failing completely. I'm not sure that mandatory replacement...
30" depth of cover is the minimum for newly installed lines, but you aren't required to maintain 30" cover. It could be reduced because of farming, grading, etc.
I would say that anywhere from 30" - 60" of cover is pretty normal, with a handful of lines being deeper.
I would imagine that...
Is it possible to remove the tank lid? Either whole or break it into pieces.
If you had the lid off, then you can just fill it with gravel, sand, etc.
If you have to leave the lid on then using a flowable fill of some kind seems like a good idea. You're probably talking some pretty serious...
I don't know that it will buy you much ground with the inspector, but irrigation lines do this all the time.
When you lay them out and turn the valve on they leak all over the place, but as the pressure builds up they quit leaking.
The nucular part of the story was definately the most unbelievable.
They made some interesting points, but I find it hard to believe that someone could misplace technology as cool as a flying carpet.
Has anyone else watched the recent episodes about aliens visiting earth thousands of years ago on the History Channel?
The one I watched discussed the pyramids and some of the other major stone ruins as well as the possibility of gliders or other flying machines. They also talked about the...
I'd also guess that there is a restriction in the line somewhere that kept the flow rate relatively low.
Having the gas/water mixture gave you the best, or worst, of both a gas or water system. You've got the compressible gas that keeps the pressure high, and a liquid that keeps the flow...
Haven't beat them, but try to annoy them once in a while.
I always get a little bit of perverse satisfaction from using one of the industrial staplers to attach reciepts to expense account statements, knowing that eventually the accountant has to pull it back out, which can't be done without a...
On the way back from lunch today, the guy on the radio said that the tar balls in Florida are from the ships, not BP's spill. Don't know if that's a reliable report, but thats what he said.
Can't help you with the code issue, but I think you may have a potential to freeze the line.
A friend of mine had a similar issue last winter and after getting it thawed out he left a tap on all winter. This past summer he dug it all up, put a heat tape on it and also burried some insulation...
The water in the pipe will tend to pull heat away from the weld, so penetration is definitely affected. The quick cooling rate will also lead to hydrogen induced cracking. Because of these two issues you need to have a higher heat input than when welding empty pipe. If the heat input becomes...
