I'm looking for some information on the force distribution on a shackle pin hole in a padeye due to the pin being forced upward. I remember seeing it somewhere but now i can't find any info on this at all. Anyone have any ideas about this?
Thanks Greg, i contacted Galvotec about their anodes and they sent over drawings and electrochem properties within 5 minutes of emailing them. They were great to deal with.
Has anyone ever dealt with obtaining spec sheets from anode suppliers? Tendering has called out for Galvotech #325 and #123 anodes for a PLET, but i haven't been able to dig up a spec sheets for these anodes, or even find a company website.
Out of curiosity, how do most people here obtain good...
No instabilities in this analysis as it is a forged pipeline flange. It's more a matter of how i've noticed some in my group use von-Mises as though it was a tensile stress. Thus i've seen some unity checks in the form of UC= vm stress/.6yield, which have always seemed over-conservative to me...
I've always considered von-Mises stress results as an "in-depth" analysis and not just a basic average stress across a section.
My question is this: Is it appropriate to compare a von-Mises stress against AISC allowables. Previously i've compared it to yield on the basis that it isn't an...
