Recent content by monk75

I appreciate the responses. My main concern was with weld sizes.

Thanks for your reply

Thanks to all for your comments

Thank you for clarifying

I'm fairly new to this site as far as asking questions and have tried to search this. Maybe I'm not asking the correct question?

Thanks for the quick response. Maybe you might be able to help further. Why does UW-21(d)state "When ASME B16.5 slip-on flanges are shown to meet all of the requirements provided in Appendix 2, weld sizes from Appendix 2 can be used? What requirements is UW-21(d) referring to? Seems to be...

Can standard 150# ASME B16.5 flanges be considered as complying to Appendix 2 flanges?

Can ASME B16.5 flanges be considered as complying to Appendix 2 flanges?

I have qualified my welders using 6" Sch 80 pipe in the 6G position. We manufacture pressure vessels as low as 10" diameter that have nozzles down to 1/4" diameter, Category D joint. We insert the nozzles through the vessel wall, but flush with the ID. We utilize a full penetration single...

Fawkes, Thanks for the post. I guess I didn't make my inquiry explicit enough. I'm actually looking for a list of manufacturers located in Europe that make pressure vessels to PED. I've looked everywhere I can think of and still can't find a list of manufacturers located in Europe. I can't...

I'd like to thank everyone who has responded to this post. I asked the same question on the CEN/ECN site and haven't gotten one reply. Thanks again, monk75

We are an ASME Code shop looking for a list of possible suppliers of PED vessels. We would prefer a list of European mfgrs as this would dramatically reduce shipping charges. Doesn't seem like the EU wants any competition from US as everything is so expensive. Any help would be greatly...

Is there a list somewhere of European PED vessel manufacturers? Any help would be appreciated.

Try ASME/ANSI B16.5 Table 3 titled Permissable Imperfections in Flange Facing Finish for B16.5 flanges. MSS SP-6 for B16.1 for cast iron flanges

Thanks to tothepoint & olgacas for their help. Lenape Forge doesn't seem to be interested in providing PED parts, but the European company supplied by olgacas was of great help. Thanks again, monk75