Recent content by mk2000

Yes apologies for the typo.

Just an expansion on my requirements: Device type: I guess it can be called a RTU technically speaking? Input signals: I have not selected the instruments yet, however 4-20mA seam to be the most common type. However I am flexible. Output signals: None required. Power supply requirements: I...

If you send me a process description I might be able to direct to a suitable solution provider. infomail555AThotmailDOTcom

I am looking for a PLC/system with the following minimum requirements: 1. Low cost! ($750 USD) 2. 6x 4-20 mA input (if three can be thermocouple input would be good) 3. Wireless connectivity via TCP/IP, GPS and 3G (ability to choose which one) 4. Ability to log approx 1800 data points 5...

I have asked this in the environmental engineering forum (Water treatment & distribution) but this might be more appropriate forum. I am looking for suppliers who can help me with solution to treat molasses derived waste. In particularly I would be interested in membrane separation solutions...

FiltrationEngineer I am very keen to talk to you about your products. Who should I contact to discuss your solutions and products?

I am looking for suppliers who can help me with solution to treat molasses derived waste. In particularly I would be interested in membrane solutions. Can anyone help me with the suppliers who are able to provide such services and products? Thank you in advance.

As hydromech mentioned look at the pipe sizing and make sure the centrifugal pump does not suck all the water leaving the PD pump running dry.

I have seen this topic a few times in deferent companies and people always argue about this every time it comes up. Even here it is being discussed see this thread . I would like to gather everyone’s experience and find out what is the best strategy to address the relationship between Part...

I am working in a company which is planning to ship electronic equipment to the USA from Australia. However I am not sure what approval is required in order to enable this. Therefore I was wondering if anyone knows where I should look in order to find out what approvals are required and what is...

FACS Do you have all the necessary safety equipment. I would consider monitoring the tank stress/strain level as well as it will give you a warning about upcoming failures. Regards

DustinMechEng Have you tried machineries handbook or Matweb

Ye12 Have you tried eProject. It cost a bit of $$$ but very function packed.

It is difficult to give you useful feedback with so little info. If you tell me bit more about the application of the diaphragm then I might be able to give you a better answer.

I would not go away form steels or even better ceramics. They are expensive but at that temp. it might be your only choice. good place to start is MatWeb