Recent content by lLouie

Hi, First of all, I would like to thank all the valuable forum users who respond to every question I ask. Thanks to you, I’ve made good progress regarding fatigue. I had asked a short question about the fatigue analysis of composites. After doing a bit more research, I’ve gathered some...

Thank you

I just want to see the effect of corrosion on life. I can't get a test done, so I'm just trying to figure it out by changing the surface roughness in the analysis program.

Thank you so much. Fatigue is already a difficult issue on its own, and corrosion is included, it becomes even more complicated. :)

Hi, Corrosion has a significant effect on the fatigue of metals. I cannot simulate it directly in the fatigue analysis software, but I am able to modify the surface roughness of the material. How much does surface roughness typically increase after corrosion (as a percentage)? Ideally, I...

Yes, you are right. As the aircraft accelerates, the temperature will also increase. Therefore, the g loads on the wing will also be very different. As a result, it is necessary to examine both situations separately in detail.

Yes, are thermal effects significant for both cases, or when going from subsonic to supersonic? I'm looking at the metal parts which are in the wings.

Subsonic Flight: Fatigue is primarily dominated by high-cycle fatigue (HCF) due to repetitive low-stress loading. The absence of extreme thermal fluctuations reduces the impact of thermal fatigue, leading to a longer material lifespan. Supersonic Flight: More severe low-cycle fatigue (LCF)...

There is a bushing between the pin and the part. I am loading the part up and down. Therefore, I expect stresses to occur in the hole area of the part, but I am not sure which contact type I should give between the bushing and the part in Ansys. I think that if I give Bonded, it will not reflect...

Thank you so much. Thanks to you, I solved my problems :)

Does maneuver time have any significance for fatigue life? For example, will it make a difference in damage if an aircraft moving at 5g cruise reaches 6g in 10 seconds or 5 seconds? After all, it will have completed 1 cycle from 5g to 6g.

Thank you, I will look at

It will be unlimited re-use, recoverable. Thanks sharing for the source.

You are right, it's weigh is too much. Almost 5.5 tonne.

Thank you very much. It is totally up to me. I will continue to search.