Hi Fabi0,
Thank you for your reply.
For my contact,
- I am using a surface to surface contact interaction in the initial Step.
- The master surface is the rigid part Choosing the outer surface.
- The slave surface is the outer shell of the pipe.
- Sliding Formulation: Finite Sliding
-...
Hello,
I am relatively new to ABAQUS CAE and i have been facing this problem for the past three weeks (asked every one i know but not many people have working knowledge on ABAQUS).
I am trying to model a contact analysis of four points on a pipe as shown in the picture in the link. The two...
Hello people, i have tried searching for information regarding this topic and i have not been able to find the information that i am looking for.
I am designing a testing jig/fixture to carry out four point bending test of a carbon steel pipe. The dimemsions are 12m long and 24 inch outer...
