This is a work at home issue. We have a user running a 1500VA UPS powering a desktop and monitor from a 15 Amp outlet protected by an AFCI. She is getting nuisance trips when she is not even working on the machine? My guess is probably when the UPS does it's periodic battery test. This is...
We are working on a project installing a submarine power cable. It has been suggested that we install load breaks in the manhole where the cable transitions from submarine cable to terrestrial cable to allow isolating the two segments for troubleshooting in the future.
My first inclination was...
OK, after figuring out that I can't count or measure....and apologizing to my long since passed (master carpenter) Grandfather for not measuring twice, etc. etc....apologies for that
The Bridge deck dimensions are 25ft X 12ft.
27 each deck boards (2 1/2" X 9" 12ft long) spacing between deck...
15’x35’ field measured. Apologies on limber size. I can’t count and am Not used to lumber this size ;-)
I’ll measure the boards and get some underneath pictures tomorrow
Regards
Larry
Larry Mackey
Greatly appreciate responses. Picture of bridge deck attached. 5 steel beams spanning between abutments. Bolts in deck boards are attaching to wood laid on top of beams (I assume but have not seen clips holding those boards onto steel beams. Many of bolts holding down the deck boards have...
We have a privately own/maintained bridge that is 15'W X 35'L. With Concrete abutments, 4-5 steel I beams spanning between the abutments and wooden decking (4X10s??).
We are working with a structural engineer and looking for a crew to do needed maintenance on the bridge. I am looking to...
Any suggestions for properly sizing HDPE conduits for 4/0 power conductors for a 2200 ft conduit run and sizing an outer conduit to nest three power conduits into?
Regards
Larry
Larry Mackey
I live in an allotment that has a bridge (rated at 25 tons) across a small creek ~30 ft span that consists of I beams between the abutments with timber deck boards (4X12) lag bolted into a board that sits on top of the I-beam (not sure I know the proper name of the component of a bridge?)
The...
I am looking for modeling tools that I can use to model a distribution feeder network that is fed power from substation(s) as well as one or more generators diversely located in the distribution grid.
We have a project where we are looking at connecting one or more alternate energy generators...
If you are running data only on the T1 then it needs to be configured as a DS1. The T1 output from the westel box needs to connect to a router at each end that converts the T1 signal into ethernet that the Ethernet to CAN Bus media converters can connect to.
As per usual...some assembly...
We used a overclocking method that sampled each RS232 data channel at ~10X the data rate. At the time I think we used a small PLD that sampled 8 RS232 channels each using a 1MHZ clock which allowed us to pass 38Kbps serial data without any problems. It was a bit of overkill but the circuitry...
Does anyone know of a reference design for multiplexing RS232 channels by over sampling each data channel as opposed to separate UARTS for each data channel at both end of the mux??
I have not worked down at this level in a number of years and got rid of all my reference designs a few moves...
This house is not in an incorporated city or township and permits are managed rather loosely by the county. While technically this would require a permit since the without a doubt is structural...since it was indoors...who knows.
The house went under contract with someone else before we could...
True...the heaving slab is in the driveway...:-) Pouring a slab on a driveway with a steep incline and not securing it to anything......gravity does amazing things :-) So does winter road salt in our neck of the woods
Larry
Larry Mackey
