Recent content by KonQueR

Can any one tell me where I can find a Laser Operator skill matrix. Thanks

Hi guys, Thanks for all the reply, Henry was spot on about power being to much. jonnyboy23, the reason why i said unfortunately for the Bytrans is that the Finger for the Bytrans is made out of Ali, ands its very easy bent. Also to get a replacement for those finger cost an arm and a leg, it was...

Hi guys, I just replace new copper slate and having difficutly with flash back when nitro cutting,I am running a Bystronic Byspeed 4020 with Bytrans (unfortunately). Is there any solution to minimise this. Any suggestions is greatly appreciated. Thanks

Hey Henry, 24hrs of Cutting 10-20mm Mild Steel and a couple of thick S/S and NO SPOT or mark on lens. Thanks mate

Thanks for that advice Henry I will change the gas pressure standby to 2bar and run a few jobs and see how it goes. I'll keep you inform. Thanks mate.

Hi Henry, We are using ByVision with this Byspeed. The default Gas pressure standby on most of the parametre is about 1-1.2Bar

Hey guys. I getting black spot and little dirt on the back of my lens. I went through 5 lens in the last 5weeks and I have asked LMC ( Australia Bystronic Rep). But it seem this guys has no clue whats goin on. They ask me to check all the seals, change the distance piercing and put more gas...

Yes Bruno,it only happen when the head is lowering. I try changing the bearing but it only work for a short time. The other reason LMC gives me is that the W-axis card need replacing but that would take 3-4weeks. The machine still work fine, quality is very good. This W-axis warning error happen...

Hi all, I am currently using a Bystronic Bystar 6kw. I have a W-axis warning error that i cant seem to fix. I call LMC (Bystronic representative in Australia) But it seem like they dont know how to fix the problem aswell. Any one out there can help me out with this problem.? Thank-You