Recent content by Kolo

Hello, I am wondering if anyone know how or where I can find information related to accessing the 1756-ENBT Control Logix module LED's within a program. I believe I need to use the GSV function however I am not able to locate any documentation that gives me the accessible Class and...

Hi anyone who is reading this, I was wondering what the difference is between a "Control Relay" and a conventional relay is? As is, I believe the control relay requires a remote signal to turn it on/off and the conventional relay only requires power applied to the coil. Cheers...

The power factor was not taken into consideration for no load cost analysis. Since the transformer running load in well balanced the power factor is high and therefore I believe the is neglegible for the running cost analysis. During no load the only transformer losses would be core...

I must apologize moturcu I am still a bit confused. Am I correct is saying that the secondary winding of the transformer is connected in series with the dc gen and that the winding needs to handle 230 amps dc?

moturcu What type of transformer would you suggest for this application?

busbar The cost was determined by measuring the no load current of the transformer and determining the kwhr/yr. jbartos exactly how would a person delay the load for the smaller transformer? Could you be more specific as to the type of protection equipment. Thank you.

anyone know what the cost of VersaPro is in canadian dollars is? Thanks

Hi there, The problem: 600V feed into a 600/240V transformer, Transformer runs continuously and the no load running cost is approx. $1200/yr. Want to use load sensing to turn transformer on. Currently the transformer is manually activated using push button switch which controls a contactor...

Thank you moturcu you have somewhat confirmed my ideas I am still a little uncertain. I though about using a transformer circuit to couple the ac test power into the output. However, correct me if I am wrong but as I understand it you are suggesting that the transformer be inserted in series...

Hi, I hope somebody can help. I have a 240 V 3 phase motor which turns a DC gen and would like to control the start/stop of the moter when I touch the welding rod to the metal to be welded. The problem I am faced with is that I need to test for continuity but to do so would require equipment...

Hi, My boss has perchased two series 90-30 units at an auction and does not have the Logicmaster 90 programming software. I was wondering if there are any demo softwares available or sites where I can download the software. Thank you for any info.