I mistakenly had a hole tapped 4-40 instead of 4-48. Normally this wouldn't be the end of the world. However, ball spring plunger only come in 4-48 in that size. Is there a remedy to this? I've attempted using a helical insert but the material is titanium and it just tore up the tap.
I am looking for a technique, machine, or part (e.g. collet) that would allow me to turn a rod about at least two non parallel axis. Does anyone know of one and could point me to the right direction? What I am trying to get is a single cross section at a different orientation (<10 degrees). It...
I am working with .020 " stainless steel sheet. I would like to create a rotational joint by placing a rivet in place and am having problems finding an appropriate rivet. Can anyone suggest a company/ rivet that I might use? I really like the flush mounted SFP SpotFast Fasteners but they don't...
I am looking for a reference that I can use to callout a laserweld on a drawing. In the past I have used an arrow followed by LBW and numbered note that specifies depth and class of welds. The welding houses I work with hate this because of how they have to verify depth. However, when I ask how...
I have an array of slots that are defined by basic dimensions (Radius, length) and a profile tolerance. I would like to dimension and tolerance the pattern but am not sure how.
If it was a hole pattern I could write 300X .25+-.004 with the attached positional tolerances and basic dimensions...
I am looking for a small quantity polymer film supplier. I'm looking for several polymers (ABS PEEK PE) in dimensions of .01-.015 (thickness) x 1" x 48-60" can anyone recommend a supplier? McMaster has ABS in 2 weeks and PEEK but not in dimensions that I want. Grainger only has PE.
Thanks
I am looking for a catalog of standard ID and OD of 17-4 SS. The OD range should be from 3-20mm.
I have the sizes for other stainless alloys but cannot find one for 17-4. Any help would be appreciated.
Thanks.
I would like to have a strip of Ti64 (cross section .7 x 4 mm) welded to a block 3 mm thick. I would like to run a seam (.2 mm deep) down the 4 mm length (from A to B in the attached image). My question is at what point along the thickness (t) of the part will the temp drop down to below 100C...
I am a mechanical engineer in need of a good manufacturing process reference. I have texts from college but they are rather dated. I need something that doesn't look at cnc as something new :) .
The equipment/processes I am looking for are laser welding, wire edm, swiss lathes, and live...
