I have a question regarding a hydraulic straightening press. This is going to be a small tonnage press (under 6 tons). Does this press require guards and 2 hand control.
Here is a second question. How can a company like Enerpac or any other press company sell presses without guarding or 2 hand...
I have a question for the electric motor guys out there. I have ran into a few motors that are proprietary. I understand the reason the motor is proprietary but what I'm trying to figure out is how there can be a motor where the frame does not fit the horsepower. Is there a special mod that does...
I was looking for a simple formula or if someone could tell me what size wires to use to measure an external 7 3/8" - 10 TPI. The pitch diameter is 7.308 - 7.301. I usually use thread mics ,but I don't go that big on the mics. I never have used 3 wires before. I looked in the Machinist Handbook...
