Thank you for the responses so far!
Here is some additional information for this transformer:
The insulating fluid is FR3.
The X/R ratio is 6.7
Total Secondary resistance is 0.12810E-02 @85C, and .10331E-02 @ 25C.
Step up transformer
65 degree average winding rise
KNAN cooling class
Where...
Hello,
I am looking to make a custom material addition for GPO-3 (Glastic) in Autodesk Inventor so I can do some stress analysis. I am having a hard time finding all of the properties that Inventor would require for GPO-3 material. These are the properties that are required for the material...
Hello,
1. The %Z from the transformer nameplate is 5.85. There is (1) bus bar per phase.
2. The spacing between the each of the bus bars is 6.25" center to center.
Hello,
I am wondering how to compute the short circuit force that would be exerted on (3) aluminum bus bars within a 3 phase transformer. Here are the specs:
2750 kVA 3 phase transformer
HV voltage is 13200Y/7620
LV voltage is 600 Delta
LV current is 1528A
(3) LV bushings on right side of...
Hello,
I am wondering how to compute the short circuit force that would be exerted on (3) aluminum bus bars within a 3 phase transformer. Here are the specs:
2750 kVA 3 phase transformer
HV voltage is 13200Y/7620
LV voltage is 600 Delta
LV current is 1528A
(3) LV bushings on right side of...
Hello,
I have a drawing that has a title block and border that I would like to save as a template to use for future drawings. Is there a way to remove the part reference in the drawing and just save the remainder (template/border) as the new title block template? I also want to make sure I...
Hello,
I am wondering if there is a way in AutoCad Mechanical to create a command that prompts a user to input a single line of text (can be multiline as well) and after inputting the text, a rotation of text prompt is given. When the user puts in 90, 180, or 270, it will then prompt the user...
Hello,
I am wondering if there is a way in AutoCad Mechanical to create a command that prompts a user to input a single line of text (can be multiline as well) and after inputting the text, a rotation of text prompt is given. When the user puts in 90, 180, or 270, it will then prompt the user...
I have a SW model (attached) that was given to me recently. The request is to change all the inside bend radii to .125". When I go to change the sheet metal bend radius, it seems to always default back to 0.045". I've tried insering custom parametrs to get the radius to change, but it seems...
Thank you Drafting Man for the model. It's pretty much what I needed. When looking at the model, why was the edge flange components in the feature tree suppressed?
I have a Solidworks part that I would like some advice on how to flatten in Solidworks. Part file is attached. I've tried using the convert to sheet metal command and the rip command but am unable to create the necessary gaps for bending. This is in Solidworks 2017. Am I better off drawing...
Thank you Kenat and dgallup for the info. Kenat is correct that my question is half non-CAD/half CAD and should have been partly asked on the Solidworks forum. I will look into getting the ASME standards for Castings as Kenat suggested. This was to primarily increase my understanding of what...
Thank you arunmrao and mintjulep for the insightful help. I have a good starting place from which to begin to understand the differences between casting and machining drawings.
Hello,
I am looking for some information regardng the differences between casting drawings and machining drawings. Specfically, what kind of tolerances are associated with various casting processes versus a machining process? Also, if I have a part that needs a casting and machining drawing...
