caseynick, you give me useful information, but as far as the height value included in the calculation, (z axis per se) when this TP is called out, is the third axis a factor?
Do I only inspect/report values of TP based on Basic callouts, or do I include deviatons in the z axis. In other words...
looking in the asme y14.5 1994 pg 53 i see that all TP callouts must have a basic dimension locating these features. If this is true and i am inspecting the part from the example shown, would I have to include the height at which it was measured to have a 3D TP calculation (XYZ), or am I safe in...
