Could someone give me datas on allowable surface pressure of aluminium under pressure of a tightened screw
The material is die-cast aluminium ref :
Al-Si8 Cu3Fe according ISO3522
A380.0 / SC84A according to ASTM B85
Could someone give me datas on mating resistance of aluminium under pressure of a tightened screw
The material is die-cast aluminium ref :
Al-Si8 Cu3Fe according ISO3522
A380.0 / SC84A according to ASTM B85
Working as gear expert in starters applications I confirm the answer of diamondjim :IF THE MODULE IS THE SAME, THE PRESSURE ANGLE MUST BE THE SAME
BUT :
the real indispensable and compulsory condition is to have THE SAME BASE PITCH pb= PI*m*cos(alfa)
SO:
you can have different modules AND...
You also need to give the tooth thickness :this will allow the gear manufacturer to determine the addendum modification coefficient in order to cut a new one.
To get this data you need to measure the dimension on K teeth (number K depends on DP & number of teeth)
If you measure the dimension on...
OK with diamondjin about SAP. Anyway, involved in design gear calculations for automotive equipment (starter pinions)one of the first concern is to make smaller everytime !
So when I design a new set of gears I try to have a minimum root diameter : I need to check by calculation there is no root...
currently I'm working on a drawing for my scenior engineering design...I got to a point where everytime I try to save, pro_engineer just crashes and I'm unable to reopen the file...the single file is made of 34 sub files..I deleted the sub_file #34 and I was able to retrieve and open the...
