We had a similar occurence which we got through our system by using their titleblock and part numbers with their own sign off area and seperate area for our sign off. Our sign off region said "Designed by Our Company" and was just added on the left side of our customers main titleblock region...
I would scale the part in a CAD system by (1-(alpha x delta T)) where alpha is the CTE. The desired tolerances should be the same as needed but the nominal size would be scaled using this technique.
My two cents being previously a design contract engineer working on outsourced projects is the following:
* You must have the design requirements fully spelled out(Tolerances, materials, ICD's, environments, weight, finishes, pressures, dynamic/random vib, etc...)
* You must require the...
When curing large quantities of partiuclar resins they can exotherm but I don't think they would actually catch on fire. I think such exotherming is associated with cyanate esters and perhaps bmi's, not epoxies.
How about bonding a fitting on the end and have it contain what ever cap seal you need? With a single lap bonded joint have the composite on the inside so that during a pressure load case the composite can't peel away from the fitting. Also Suggest using an aerospace grade structural adhesive...
Spinda,
at 1000 deg C tradtional composite materials will not work. Even more advanced resin systems such as polyimide or BMI have Tg's of only 400 Deg C. But, you may be able to use Carbon-Carbon composites which have the resin burned off and infiltrated with carbon. C-C can maintain strengths...
ctopher,
thanks for the response but I guess my question is more related to view creation fundamentals rather than the particular drawing I have shown. The drawing I have shown is just an example where I am really interested in knowing whether its acceptable to have projected views not at the...
All,
this is a simple question so I'm sure it won't strain anyone's brain. I had a discussion with someone at my work this morning about making an auxilliary view not being at the correct projected angle just to make the drawing look nicer. For the case that a tradtional auxilliary view won't...
Tapirg,
From my experience I would recomend using alot more pressure during the cure to evacuate the higher level of volatiles associated with phenolic resin. I would say at least 60 psi would be necessary assuming that this much pressure doesn't damage the foam.
Josh
We are pretty close to you in San Diego and could easily engineer/test such a structure:
Josh Moore
jmoore@sdcomposites.com
San Diego Composites, Inc.
http://www.sdcomposites.com
All,
My only comment regarding metric default tolerances is that going to 3 decimal places in metric is almost useless since .001 mm is .00004" !!!
JMo
David,
download this Laminator program which uses laminate theory to make smeared properties from lamina properties:
http://www.thelaminator.net/
Josh.
I don't think anyone mentioned this...Changing jobs frequently may increase one's pay too much. If someone gets around 20% raise every time they change jobs, this may cause their pay requirements to be too high for the kind of work they do, thus causing them to be a less desirable employee. Who...
All,
I came across an equation for a correction factor for RSS tolerance analysis and was wondering if someone here could ellaborate on it for me. I have typically used a 1.5 times the RSS tolerance stack type of adjustment as compared to using a worst case tolerance stack. But, a customer...
Hello all,
I am a new NX5 user and ran into a problem I would think would be simple to figure out but got a little stumped. I made a part in mm but later wanted to swith it and all the dimensions to inches. The only way I found to do this was by using the NX command prompt and typing...
