Thanks guys...
Meng Project Management - Ive heard some mixed reviews, but it seems that the general consensus is it doesnt provide the value the other two options do
Meng Petroleum - I think there is obvious benefits, it can really help bring my upstream knowledge up to a level that the other...
Im looking for some advice.
Im a young engineer (24) and have done pretty well so far in my career responsibility wise. I currently have several million + dollar upstream projects under my full control from design through to execution. I work in a relatively small oil company and therefore...
Hey guys, when a progressive cavity pump downhole in a CBM well shuts off, will the fluid column above it stay and safely isolate the gas flow from moving up through the production tubing?
I have a downhole pressure transmitter that goes through a PLC with some other instrumentation to...
Thanks David....so my understanding of this is you use the smaller diameter tubing to increase the velocity and carry through the liquid? Losses in the tubing would make this a smaller value than through the casing, but its still possible.
Hi all, Im wondering if it is possible for gas to go up the production tubing for a CBM well.
IMO, the maximum pressure of the piping needs to be that of the max deadhead pressure of the pump, but is it possible for the gas to go up the production casing and see bottomhole pressure in the case...
Hi all, I was trying to get some information on well completions...the well is completed now has been tested, and is cased in awaiting some faciltiies for free flow oil production.
In the near future we are planning on adding a pump to the well, either a beam pump or an ESP, and I wanted to...
Im attempting to estimate the costs for a natural gas compressor station on a 42 inch line.
So far Im looking at a GE or Rolls Royce 211 Driver (around 15-25 MW) and I have to select a compressor (currently looking at Dresser Rand Datum compressors.
The inlet pressure is 6.5 MPA, and the...
Tickle, my general understanding of the engineering grads there is with what your saying. I have one strong chance at a pre-graduation job and that is with a friend at work here who worked with a coal seam drilling company out of Brisbaine. He highly recommended this company as to their...
My degree is from a university recognized by the australian government and the engineering organization there.
There is a large group of companies that come to my university every year to recruit engineers to australia, estimates say there are over 100K engineering jobs in aus right now.
Hi all, I am going to pursue my engineering career in australia after graduation and was hoping to get some recommendations/help.
I am currently finishing a 16 month work term at a very large oil and gas company. I worked as a project engineer for most of the duration finishing a 1 million+...
Ive had this EXACT problem on one of my jobs.
First we used a vac truck on the closed line to suck as much water as possible out.
Then we blew dry steam through the line until the temperature of the entire line reached ~ 300 F. Read using a temp gun.
Then we blew nitrogen through the line...
I have worked as a project engineer for over a year now and recently finished my first big project. I have no doubt that project engineering is what I want to do so I may come off a little biased. My favorite part of being a project engineer is looking at the big picture, starting from front...
TenPenny is correct, CRN's are required for pressure retaining equipment/parts here in Canada. They do not need to be to a specific code but the registration does ask for what code they are designed to. They are then approved by a P-Eng at the local pressure vessel authority for the province...
