Recent content by jerry1423

I hope this is the issue. RMC on drawing view and go to Settings. Jerry J. UGV5-NX1899

I assume it has to do with Clip Planes. I am not at work now, so I will try to get back to you later with a solution. Jerry J. UGV5-NX1899

Sorry about the delay getting back to you. The first two are pdf's. The bottom ones are videos. https://www.appliedcax.com/docs/portland-nx-users-day-April-2018/NX-Assembly-WAVE-Link-Demo-and-Tips.pdf https://www.swooshtech.com/2021/02/12/wave-geometry/...

Maybe this will help you. https://community.sw.siemens.com/s/article/nx-shortcut-keys-view-full-list-and-create-custom-keys Jerry J. UGV5-NX1899

Maybe this post will help you. https://community.sw.siemens.com/s/question/0D5KZ000009ASzZ0AW/creating-a-dropdown-list-in-draft Jerry J. UGV5-NX1899

I found this on YouTube pertaining to what Cowski mentioned above. I am very interested in learning it, but it does not mention what version of NX was used in the video. https://www.youtube.com/watch?v=ZjvO3zT-89U Jerry J. UGV5-NX1899

You will probably get good results searching in YouTube each of the four bullet points that you mentioned. I will try to get back to you when I have more time. Jerry J. UGV5-NX1899

I am sixty years old and never learned how to type properly. I am still just a pecker. Does anybody have any suggestions on the best way to learn to type ? Jerry J. UGV5-NX1899

It appears that it can, but I am not certain of that. If you go to the below link and read under "There are two ways to open a NX part file in Solid Edge:" you should be able to find what you are looking for. https://www.soliddna.com/SEHelp/ST5/EN/i_v/ugse1a.htm Jerry J. UGV5-NX1899

They can't, you will need to figure out how to add material for them to join to. A few thousandths will work. Jerry J. UGV5-NX1899

Here is something that I found that may help you. https://community.sw.siemens.com/s/question/0D54O000083Yc0USAS/slow-postprocessing Jerry J. UGV5-NX1899

A couple questions: What version of NX are you on? Are you on Teamcenter? Jerry J. UGV5-NX1899

It will take a longer amount of time to save the first time the file is saved in the new version NX, but the save after that you should see an improvement. Let us know if that is not the situation here. Jerry J. UGV5-NX1899

Run EXAMINE GEOMETRY on all the solid bodies before and after the unites or subtractions that you do. Jerry J. UGV5-NX1899

Why is your font gap zero ? Jerry J. UGV5-NX1899