Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Jeffrey Stankiewicz

  1. Jeffrey Stankiewicz

    Tolerances for taper of plasma cut bolt holes in structural beams/parts?

    Was trying to find an AISC spec or other structural steel code that contains a tolerance for taper in plasma table cut holes in base plates, connection plates, etc? Can anyone point me in the right direction? Thanks, Jeff
  2. Jeffrey Stankiewicz

    Fabrication tolerances for AISC structural shop

    I've been scouring the 14th S.C.M. for shop fabrication dimensional tolerances. Specifically: parts/cut length, hole center-to-center, end plate/base plate "squareness", etc. So far all I can find is hole center to edge distance (Table J3.4 in the Spec. for Struct. Steel Buildings) and "member"...
See more

Part and Inventory Search

Back
Top Bottom