LittleInch, thanks for the response.
This will be permanent use for elimination of flaring to generate power. Around 10MMSCFD so I'm estimating around 40-50MW power potential.
I have a high mwt. fuel gas, which has a very high proportion of LPGs. This fuel gas is 60mol% C1, around 16% C2, 12% C3 and 5% C4. Mwt is 25.1. LHV is around 50MJ/m3 and it has a high Modified Wobbe Index.
My question is, is this fuel suitable for an aeroderivative gas turbine?
I have seen...
I have a predominantly methane gas feed with approximately 2,000 ppm H2S. What are the options for removal? From what I've seen:
1. Liquid scavenger: PPM level is probably too high, but why? Is this to do with OPEX or because of reaction byproducts? What are the reaction byproducts?
2. Amine...
Hi George,
Thanks for the reply.
I know the exact metal temperatures during depressuring, and they are below the MMDT of the metal. My question is really whether the material needs to be heat treated and impact tested, either or neither as the minimum predicted temperature is only a couple...
I have a system where the predicted metal temperatures of carbon steel flare piping are lower than the MMDT of -29°C. I'm trying to figure out the allowances given in ASME B31.3 Chapter III to see if I can reduce the allowable minimum temperature.
The material is type 3 in Table 323.2.2...
