sorry about my post. We are having some bad storms so I will try later. This is the color standard I haveused in all industrial plants plus the USAF for over 20 years and all equiment I build or install. Motor Centers and so on.
OK here we go.
Color coding for pushbuttons, indicator(pilot)lights and illuminated pushbuttons. ( NFPA 79 Industrial Machinery)
___________________________________________________________
COLOR Device Type Typical Function...
The best basic book I have found will give you all the information you need.
Electrical Power
Motors, Controls, Generators, Transformers
By Joe Kaiser
I hope you can use this information.
I recommned Allen Bradley with RSLoxic software and wonderware, which is runing on an Windows 95 machine hook-up to the network to monitor whatever you need to do and control your I/O. On the other equiment I use different SLC 500 racks I use has a rack with 9 input slots with 2 output slots.
You stated that you are using a motor with a slipring !
1-On what type of maching are using this motor ?
2- Are you taking about cluch & Brake slipring to control a milling machine ? This type is used to control speed and braking and is mounted to the end of shaft of the motor.
??????
Machine Builders and Industrial Electrical standard insulation Wire Color code for most Industrial Plants.
Blue = dc control wire (24vdc) to (120vdc).
Yellow = 120 vac from an outside power source.
Red - 120 vac control cicuit.
Black = 120 vac (x1) Hot wire or 220 vac
White = 120 vac netural...
Vortex coolers are good to cool down some non electrical equipment. But if you use it to cool your control panel I would make sure you had a very good air dryer system. If you do not, then the water will cause your PLC to short out along with your other electrical equipment. If you must cool...
