Recent content by hrvisser

Why don't you use create in place or partcopy? and place (using partcopy) the new part which dragging with crtl pushed down? Henk

I put a non-graphic part into my assy, by holding down the CTRL key. The part is GROUNDED.

I totally agree with Patrick. The hybrid approach in SE is very powerfull. In V15 you can use Çreate 3D'. Drafting is stronger than in SW as far I know. I use SE a lot, SW much less and I don't have Inventor. I like SE the best. Henk

first make a NEW line style almost as discribed by fwc 1. Select Format>Style, the Style Dialog box will appear. 2. Choose NEW give it a name "Visible Red" based on "Visible" 3. From the ‘General’ tab set the colors. 4. Close the new linestyle. 5. Select de Drawing View. 6. Properties (RMB)...

take a look at www.PARTserver.de

step 1 make a sketch step 2 project curve on the sphere step 3 normal protrusion step 4 pattern this is the way I would try it

Two possible ways Why not open a new assy, set the first assy as a subassy in the new file. And that subassy again in the new assy? Your new assy contains also 2 times the same subassy. Create a circular pattern and use 180 deg.

IE gives also with other appications problems. Our reseller of administration software FORBIDS the use of IE 6^ jwillison why don't you use the quadro drivers?

Why don't try to get the most out off Virtual Studio (ray tracing) in assembly and then Photoshop for the finnishing touch? Henk

Hi All Don't forget the aftesales. Inventor would be a bit cheaper in buying (in my situation), but ask also the prices for surport and training. I didn't believe that. SE was and is very costum friendly toward me. Support is very very and again very cheap. Henk

Yes it is outside SE. I use WinNT. Go to START then RUN and type REGEDIT a new program starts. On the left side you find the HKEY_CURRENT_USER and under that the key SOFTWARE. REGEDIT is tricky. So it is a good thing to save it first. REGEDIT REGISTER EXPORT Because I have NT in Dutch the last...

If you want to restore default toolbar on SEVx try to open with regedit the following key HKEY_CURRENT_USER\Software\Unigraphics Solutions\Solid Edge\Version x\ToolbarSettings Just DELETE the subkey "Version" (usually with value = 14) and the job is done on next SE restart. more...

Your graphics board does not refresh frequently. you can look at the properties of the card (how much memory?). Look for a new driver or ask your reseller. (the way) You can always hit F5 to refresh your screen (bad way) greetings Henk

try to contrain every thing to the reference planes. Do not use include to features. Feature lost... Use include on SKETCH. Place dimensions always in the same order as the profile. clock wise or counterclockwise. But those things you now. look in mechanical quarterly fore better help. to easy...

thanks I 'll try it Henk