Recent content by heyjay

OldPost, you are exactly correct, in dicussions with my engineer the epoxy of the threaded rod does not appy, he specified it only for positioing purposes with placement. no strength derived for calucating moments. thanks

I would not use TCP for critical applcaition where delays would cause a problem,i.e. Steppers, High Speed counter, Life Saftey applictions. By it's defined protocol TCP will delay in certain events, Collisons, no response from request and most damaging the complete dropping of packets. TCP is...

thanks for the reply, but what does code say about this application. My building inspector say usually the epoxy is not applied.

I am a contractor located in Los Angeles,where my engineer calls for a threaded rod of 7/8" dia. placed into exiting concrete footing (24" deep) and then 6" embededment into a 12"x24"24" unpinning concrete pier with a 4"x4"x.25" washer plate attached to the end(in new pier). My question is, does...

I see you have a sense of humor Bill, Very Good. I am looking to clamp a variety of differant products of variing sizes into a fixture/clamp for mounting onto tooling plate. Hopefully i can find a fixture/clamp with a quick release or easily disenganed mechansim so it can dismount from the...

Gosh, why didn't i think of that??? A Vise..huh.

I am looking for a plastic clmaping fixture that can accomidate a large range of products (2"x2"x2" thru 6"x6"x6"). Clamped in one direction is ok.

I know it's late, but I have extensive expience with Ectroc-Craft products. heyjay@pacbell.net

I have used a .ocx from Autoamted Solutions that will talk to the most popular of AB products via Ethernet, KTX or DF-1. I think its a superior product because i can control the timing and programming methodolgy that works best for the project. Otherwise you have of conform to AB gudilines of...