Hi folks,
i’m still really unhappy by meshing floors with areas. I handled to mesh the geometry manually, which is irregular, in six big quads. So far the model runs without warnings. I tried to generate a finer mesh by dividing the areas into sub-elements to get the proper deformation of my...
thanks for the answer. the command merge points is a powerful command which i have not known. thanks. but i'm still not able to fix the following warning:
2. UG, F4 & F413 are too close. Check at (179,622,296,385,3,15)
2. UG, F413 & F414 are too close. Check at (161,803,262,212,3,15)
Check...
Hello,
I try to mesh manually a floor of an irregular geometry by dividing the area at lines (shell elements). When I check the model, I get the warning message: areas "are too close at points...".
Has anyone an idea how I can fix this warning. I'm not able to mesh this geometrie proper. In...
