Recent content by g114

Hello Group, When I was on the USS Roosevelt, the munitions handelers would load the fuel tanks and munitions under the wings of the fixed wing aircrafts using a 4 or more wheeled dolly that had a craddle area to hold the tank/weapon while being lifted up to the wing. Does anyone know what the...

Thanks, to all that have replied. The application is a switch for applying pulse widths of various widths and voltage magnitudes to a terminator to determine the amount of shift the terminator experiences.

I mean, I would like to use the device to create pulses of 1us, 10us,... up to 50us. I will look at IGBT's. Thank you.

I would like to switch between 1us and 50 us.

Looking for a mosfet with: 1600-2000V Vces rating; 30A Ic rating; and low Rds(on. I've looked at Digi-Key and Mouser and found IXYS's 40N160, but would like an alternate. Thanks in advance.

Hello All, Excuse me for asking what probably is a question with an obvious answer, but if an attenuator's S21 parameter is smooth for a given bandwidth, should the S11 parameter also be smooth for that bandwidth? I would think yes, but my measurements seem to indicate otherwise.

It is a 50ohm surface mount thin film resistor. Thanks to all that responded!

Hello all, Hope this is the right forum for this question. I have a resistor with one input terminal and two output terminals. At first glance, I thought the device is a power splitter (or combiner), but it is not characterized as one. So, what type applications would a three terminal...

I have looked at the North Carolina State University software, but have been told the results were unreliable. Is this true? thanks, g114

Hello Anyone, Does anyone know of commercially available software for generating IBIS models from PSPICE or HSPICE models? As I am new to the whole idea of IBIS modeling, any experience anyone would like to share with me about developing models for passive SMDs would be appreciated. I have...

Thanks kenvlach

Could anyone point me in a direction where I could find out more information about AIN?

Anyone know of a good supplier of AIN?

Is there already an existing forum/thread on RFSim99? I would like to know if the software is capable of generating a VSWR graph. Additionally, the graph that it generates does not allow for much display modification. Am I expecting to much from freeware?