Recent content by Frokilin

Thanks ferdo. Engineering Connections I have never used and it's giving me an error when trying it. Robot I don't think it will place the part exactly where I want it and Snap is translating the part but not rotating it, and I need that rotation so all the cylinders are aligned

Hi, I have a Physical product that I want to move to another one. Basically I need 2 Cylinders to 2 cylinders and 1 plane to 1 plane to match. In the Assembly design app, I have used the Snap move to match the plane to plane, and one cyl to the other. I am stuck because now I need to rotate...

Thanks Burunduk. That is because of para. 4.3.1 (b), right?

Would that diametral 67.5 size tolerance be covered with that linear tolerance note on the drawing notes?

Refloating this In regards to that, wouldn't the para. 11.3.1.5 in Y14.5-2018 cover the all over? It doesn't specify to say "all over" when you place the note in the drawing general notes? "All Over Specification. A profile tolerance maybe applied all over the three-dimensional profile of a...

Got it. As mentioned above if the note "model is basic" that would mean no basic dimension is needed for the surface profile to control the location? is that on the Y14.41 standard (I don't have access to it) mentioned in paragraph 5.1.1.2 (d) : "Basic dimensions shall be indicated on the...

But like True positions implies "the theoretically exact location of a feature of size, as established by basic dimensions" The True profile doesn't relate the location to a basic dimension?

Thank you both for your replies. Where in the 2018 standard implies that the surface profile controls location only when there is a basic dimension? I can't find it. I guess using the "all over" from that paragraph should work in that case. But, personally, I a trying to convince the designers...

Got it now, with that wording I understood. I knew I was missing something but couldn't picture what. Thanks!

But then, on my example above, aren't the tolerance zones the same on those surfaces for a surface profile with datums and with no datums? like couldn't both surfaces on both figures be anywhere in between the red dashed lines? I never paid attention to that figure, I wonder, if the control was...

Isn't it profile with datums contoling shape, size, orientation and location, as mentioned above, and without datums same but no location? But I guess what I don't fully understand, if I had let's say a block with datums ABC being a plane, hole and slot, all of them prequalified. Then a surface...

Hi, I have read some post but I didn't fin a clear answer for this question. When you have a drawing with datums defined, and a general note saying "Unless otherwise specified profile tolerance of: " What is the difference between having that surface profile called out back to datums or called...

Appreciate your answers, as you said, unfortunately I am kind of stuck with the creation of that drawing. I understand your reasoning but let me explain the "workflow" that I have in mind, it kind of makes sense in my head but I might be wrong: Part level drawings are created, and parts will be...

Thanks for your thoughts! Is not that we will measuring in the CMM every single of these assemblies, but we need the Assembly level drawing, that was why I wanted to know the best wat to call that hole out in the drawing. If later we measure a few times on the CMM and then use more often a gage...

This is a good idea, but I kind of wanted to have it as simple and faster as possible. That's why I was thinking on the customized DRF. If parts are in spec at part level they won't be rejected at the assembly level. Assembly level drawing will come from the stack up, so spares part should work...