Recent content by frankiee

When using a Fluke T+ (or other voltmeter) to do a potential check, to make sure the circuit is dead,can any residual voltage in the circuit light the 12 volt bulb and make it stay on? I can imagine that the 12 volt light could flicker on with any residual voltage and then I imagine that it...

rmw. My plant here in Ontario has 4, 15,000 KW non seismic all with separate fuel source and 2 CTs for emergency that are seismic and 5MW each

http://definitions.uslegal.com/s/station-blackout-energy/ The above link is what I found on the net. Now in the case of a multi-unit station that has non environmentally qualified stand -by generators (SG)and 2 environmentally qualified emergency power generators (EPG). A black out would mean...

Does anybody know the definition for station `Blackout` for a multiunit station? Thanks

Original post had an error I meant to say coming back from generator it is about 0.05 micro Siemen/cm

Original post had an error I meant to say coming back from generator it is about 0.05 micro Siemen/cm

For Demin water stator cooling system Why is the conductivity lower coming back from the generator then going to the generator. Going to gen after HX and IX is about 0.13 micro Siemen/cm Coming back from gen is about 0.5 micro Siemen/cm Temp coming back is about 60 degree C Temp going to gen is...

For Demin water stator cooling system Why is the conductivity lower coming back from the generator then going to the generator. Going to gen after HX and IX is about 0.13 micro Siemen/cm Coming back from gen is about 0.5 micro Siemen/cm Temp coming back is about 60 degree C Temp going to gen is...

Can someone tell me how to properly read a gauge for oil level in a transformer conservator tank that is marked by degree temp Celsius.

I was able to get an answer from one of the lab rats at work. It is Lithium and Oxygen and Deturium Thanks

I am reading about the purification system of the Heat Tranport System of a CANDU reactor and I keep seeing a reference of "LiOD" It is the addition of Lithium from the IX columns to the D2O to control the PH at around 10 Does LiOD simply mean Lithium + Oxygen + Deturium ? Thanks in advance

Yes. To think about it it would not work. Too many variables

I wish to read the amperage of individual circuits on a main power electrical box. The individual wires in the box are a tight fit for the clamp of my inductive amp meter. Can I rig up with wire a wound loop around the wire in the box then measure the amp draw from that wire core? I realize that...

I was thinking that it would have more to do with the fluid moving thru the engine block so fast that low pressures would build up around the jacket areas and form a boundary of air bubbles in certain areas where there in next to no heat transfer thru the bubble film. I wonder if anybody has...

Oh great MintJulep! Just as I was going to post to engineer "B" and eat crow telling him that he is right and I am wrong, you offer me a glimmer of hope that it is in theory possible. That is what I was thinking that in a real world engine block that there would be so many calculations to make...