Recent content by Firerunner

Hello, I can't figure out why when I copy something, inside autocad it takes up to 10 seconds for it to paste?

Hello everyone I there a way to setup layer property filter through Autolisp without actually going through layer manager?

Thank you so much. I forgot albout that I haven't done any lisp programming in years

Hello every one I have a smalll lsp routine with a dcl file. I tested it yesterday and it worked for me. I need to share this fille with others in our group.I both files to another directory, and now i get a undifined function error. I iot to my laptop and get quit / exit abort error message Can...

Hello everyone. Does anyone know where I can get a Lisp Routine that I can get the results of the attach XLS file. I tried the extraction Wizard and it doesn't give me what I everytime I always have to change something. Thanks for any help you guys can provide

I've tried it before and didn't like it to many options, I'm to get to the point were there is not that much info to manually enter.

I'm back again with a question about attribute extraction. I tried using the attout, but I noticed that i don't get the device x,y corrdinates.Is there a code I can add to attout that will give me the corrdinates? Thanks

Is there a way to explode a block that has been setup not to explode

thanks to all I gave the person that asked me you suggestions

Is there a way to convert a spline to a pline? Thanks

Thanks to everyone that responded

can anyone recommend good books about programming in autolisp, or any sites that have good tutorials for beginners? I would like to try and do stuff with dialog boxes and some short cuts for work. thanks

Is there a way to extract block info, while using a window/crossing then export it to a file. I have used the Attribution Extraction in Autocad but it doesn't give me what I want. What I am looking for is the following: Address Block name X y z rating info I also am looking that...

That was it I move it to the top and is working fine now Thanks

That was the first place I looked. it shows American English I also checked the setvar value. I just found the enu.dct file in the support folder