Recent content by farahnaz77

thanks all for your useful advices.

I'd like to know about seal flushing and quench system used for a centrifugal pump. I have studied API 610, app.D, but I'd like to know how and based on which condition a seal flush plan is selected. when a quenching is also required? Thanks in advance

I’d like to know why on connecting pipe between a cooler/condenser located after a gas compressor and receiver/drum there is no valve? thanks

When a storage tank is blanketed with Nitrogen, which case is better : applying one control valve on nitrogen line entering the tank or 2 control valve, one of them on entering N2 and the other on outgoing gases and N2 from the tank. In first case outgoing gases can be drained through PVSV.

I have a question about body material of valve. Which type of material is suitable when the fluid is contain 25% (mole) of CO2 and 75% H2S? Can carbon steel be used as body material or only stainless steel is suitable? What ASTM codes are used for this case? Thanks in advance

when "A" letter is used as third letter in mechanical seal code as per H-7 appendix of API 610? what about "T" ?

thanks all; in equal conditions, when a single stage pump with 35 kW hydraulic power is needed, which is preferred?

where can I find that a fluid is corrosive or not?

how can I determine flow rate and discharge size of a pressure safety valve installed on upstream of a knock out drum?

where is the demister pad used in a knock out drum; in other word, when there is no necessity to use them?

what are the differences between Between Bearing centrifugal and Overhung pumps? where is used each of them ?

first, thanks I meant the pressure of gas at connection point is 2bara ( at 12" pipe),i.e. after calculating and considering pressure loss.

I need some basics about back-pressure. My problem is about sour gas flowing through a 12” pipe(branch) with pressure of 2 bara @ 39.45 deg.C. can it enter into a 52” or 24” header which sour gas with press. Of 1.5 bara @ 38 deg C is flowing through it? thanks

Does anynoe know a shortcut to calculate heat transfer between fluid in insulated pipe atmosphere and also between insulated storage tank and surrounding air? thanks

How can I calculate the proper flow rate for styrene monomer recirculating in order to avoide its polymerization resulted by heat transferred into the long pipe fluid? which consideration should be taken into account? Thanks