fuseshut,
I calculate the U1 output to be ~8.3v going to some load. Since the D1 see 8.7v on the anode and 8.3 on the cathode (~.4v) this diode would not be turned on and the RC battery would be charging thru the main battery. When the main battery starts going lower than the min drop...
killabyte,
by the way this would be an inverted signal so if that;s a problem you might have to use a second transistor to get back to the original non inverted form.
-elf
killabyte,
You might be able to use a single transistor to convert the logic 5v by driving the base with the logic (5v) then using the open collector with a resistor tied to the 12 or 5volt ps with a zener to set the 2.9volt level to the cmos.
-elf
nuclearsiloman,
Your right they leave off the bvt when searching, They got me. Is there any way of makeing the dual device (8pin) fit your in your prototype?
-elf
nuclearsiloman,
If you search crosscomponents.com you will find that they show they have 155ea of this device. You may also want to try partminer.com
-elf
raivo,
The simple answer is that almost any supply can be a current source, although different load types may favor different output types. The main feature is the feedback. Measuring the current thru the load (not the Voltage)by a series resister (shunt) or with a hall effect probe or a...
danap2005,
Ir is right, any mechinically touching parts are usally enclosed in a case sometimes with exhaust ported out to a gray area (class 1000 or so). In addition most surfaces above the process parts are structered to allow clean air (class 1) to laminar flow without turbelance...
TuckFel,
I feel your pain. Hardware even it it's bad can just be changed out more frequently or have it's maintenance schedule time decreased. Software on the other hand is diffcult because on one walks around with source code and compliers to fix these types of problems. I like to have...
tomhl100,
Sounds like a anode for a rf etcher. Its common to place a Silicon wafer on a plate (cathode) & place above it a anode with holes to feed argon, silicon tetafloride or other gas into a vacuum chamber just above the wafer. Then rf is introduced on to the catode which excits...
drpappy,
Some people use a soft start circuit where they place a current limiting resistor in series with the output of the PS. When the voltage comes up to the proper value they energizes a relay that shorts out the current limting resistor and connects the load at the same time. this...
Hi Skogsgurra,
Yes your right about the question of noise, just adding to the conversation. Yes, I have no experimental evidence that would indicate your wrong on your sqrt of the sum of the squares formula. I think it just seemed logical to me that the THD's would be additive. I...
2sb18,
I don't think that slowing up the switch signal will work on this device. It looks to be driven by logic gates which will switch when the threshold voltage is reached. You might try using a single fet for each switch and ramping the control signal as stated above. If using a low...
skogsgurra,
Just a question, How does your formula work if you input a signal into an Ideal .3% thd amp would you not have a circuit with < .3 thd? Then that signal into a .6 Ideal amp which would add another .6 thd. This would seem to be true if the circuits were independent. If not...
