Hi,
I am trying to flow steam into a chamber using a ideal variable componet, using water ideal gas and air ideal gas, but when i run the calulation I am not getting what i expect, i have buoyancy switched on etc.
Has any body tried this before? am i using the correct approach?
I have a round on a part, of 0.5mm, but when i edit the main extrusion of the part to 10 meters long, the part crashes. the same if i have the part 10 meters long, the smallest round it will let me enter will be 1mm.
Is there some setting somewhere i can change?
thanks
P
Hi,
I have a 12mm thick beam and i am feeding wires through it. I am currently using a plastic cable gland, but i want to use some type of rubber grommet. The cable size is about 18mm in dia and i need the grommet to seal(IP66), but it needs to fit this 12mm thick beam, a lot of grommets are for...
HI,
I am looking at using a plastic molded can to house some electrial parts. It is going to be used in a hot and humid enviroment, about 60 - 70deg C. I have to make sure that the can can't leak or any moisture enter the can. The dim of teh can would be 170mm x 175mm x 275mm, the top of teh can...
I have a load in a horizontal furnace, i heed to turn the load that it is vertical, it is some wafers in a test in the lab, does any body know what effect this will have on heating the wafers up uniformily?
Is there a design of element / baffels i could use?
Thanks
i was looking about a single part, when u give a part a attribute, like material, can you make this attribute appear in the title block of the part its self?
Can use it and it does improve, but it is not a "vacuum" cool down. We have to keep it at the same pressure, 1 x 10-6 Torr.
Convection tru the part to its stand might be a way, but the part is sitting on a quartz plate, so won't get much heat flow thru that?
What do you think?
There is a jacket on teh chamber, water cooled and it runs through out the process, the partsare heated up to 480C for a time, and then elements are turned off and cooling begins.
The radiation between the parts and the wall is not good enough to give a quick cool down, there is a quartz heating...
Hi,
I have a chamber which is in Vacuum, and I have parts that I want to cool down. The problem is the vacuum! The parts are cooling very slow, due to the fact the only heat transfer is radiation. I need to speed up the cooldown? in a controlled mannor. I have to keep the parts in a vacuum until...
HI,
I am looking for stainless steel which needs to have a dull fininsh, i need the best heat transfer, heat transfer to teh stainless is due to radiation on one side, and water flow (forced convection) the other.
What finish can I get?
Thanks
