Recent content by digger200

Thanks for the replys

Greg, Would cargo restraints be designed to this figure? What loads are seatbelt restraints designed for? Thanks Mick

I would like to place some tiedown points on a trailer bed to secure small loads (80Kg) within a compartment. What sort of G forces could I expect in say a 30mph crash. Is 5G a reasonable figure at this speed? Thanks

Thanks Guys, now I've seen your HLOOKUP method I've used that. Thanks again

Thanks for that. I've decided to write a macro with the data in that.

I want to use equations that use data from a table (on the same worksheet would be nice) So how do I go about it. Imagine my equation for a certain model is 2 x A, where A is situated in the data file (row?) and depends on what type the base model is. (I can't seem to find what I want in the...

I think a true crown only works if the load is central. With a spline the bar twists, so using a slight helix may be better but then you have an assembly problem.

Have you contacted DB at Huddersfield?

Sorry lads , I might have answered my own question. I could mirror the sheet metal & cut the piece off. Is that the correct way?

I forgot to add it a sheet metalpart

my mirror part is greyed out (Insert/Mirror Part) and I therefore can't mirror the part. Any suggestions as to why? Thanks

Instead of heating the inlet, how about a small wattage heating coil in the main tank, or piping hot water through it?

Thanks Guys

Can anyone tell me what minimum clearance I could get away with between the sides of a road trailer tyre and a frame. I have always worked with 25mm. Thanks

same here, what would we do without the internet?