Take a look at Helical end mills. www.1helical.com
We're running 500 sfm in 6-4 Ti. The key to HSM Ti is very small stepovers. You want the cutter out of the cut much more than in the cut. Say 10-15% radial stepover. Since you are taking such small stepovers, the only way to make up for...
Thanks guys. The part is too big to use a BP or drill press. The features also have to be bought off on the machine also. Our designer is coming up with a spring loaded micro stop for a CNC machine. I'll let you know how it works.
-Derek
None of those options are acceptable.
1. Its not our part. Its for a large jet engine company. The part has been in production for 15 years. Getting a print change is impossible.
2. We HAVE to cut major hours (200+) out of this part. Fixturing it from that surface is impossible...
I'm sure someone here has ran into this problem before.
We have to put counterbores, or spotfaces, whatever you want to call them into a cast surface. The dimension is held from the cast surface. Since our castings vary more than the tolerance given on the depth of the spotface, we're having...
Surfcam may be easier to learn, but is not better, IMHO. UG CAM is probably the most powerful CAM software available. You have total control over the tool, and is highly customizable for your site. It all comes down to what kind of work you do. Big selling points of UG are associativity...
You will be alot happier if you can learn to live with rap1, rap2, rap3. I suppose you could abort the event, but I wouldn't recommend it. Just my opinion. To answer your other question, which isn't too clear, 'initial move' happens right after a tool change. First move is like an initial...
This is what I've always done if I wanted to start exactly in the center of a hole without using predrill points.
1. Hole dia - cutter dia = A
2. A / 2 = B
3. B / 2 = C
4. Set arc engage size to C. Set horizontal clearance to C (NX 5, set arc 90 degrees).
5. Set cutcom minimum angle to 45...
(and don't confuse this with Visible in View as that's something we would really like to get people to stop using)
Please, please remove this function!! I detest it. I have a few stubborn co-workers who insist on using this to turn on and off layers. First they go to 'Visible in View', turn...
Transform or instance the operations like jelmerra says, then put the transformed operations in a new MCS with a different coodinate system. There is no need to transform the models, or any solids.
-Derek
You know there is a custom command already included in UG for a Z/W axis. You only need one post. Unless your machine is different than what I'm assuming. But to answer your question, you need to link the posts inside the post. There is a tab for linked posts, you need to point to each...
I don't know if this would work in your application, but I've knurled oversize bores to get a press fit. Keep in mind the contact area is dramatically decreased, and your bore might not hold your bearing anymore. Use a straight knurl. The bad thing is cast iron doesn't knurl too well, but you...
Taken from MMS online:
"C. Inverse Time Feed Control
Most NC programmers think of the F-register in a CNC controller as the method for specifying linear velocity, i.e. uPM or uPR. This is true for two- and three-axis linear motion, but when rotary motion is to be controlled, the F-register...
