Recent content by daveo

bpatt, the problem in the end was that the dat device was dds4 and was not backward compatible with orignal dds tapes. thanks for your reply.

I've managed to find the 'time to the onset of cracking' using a transient analysis, Daveo

Dear all, thanks for your info, but unfortunately our IT sub contractors took away the machine and reformatted the disk. However, like SVANELS pointed out the machine count not be started in DOS mode due to the absence of the DOS mode partition, but Til's solution may have worked. Our IT people...

External HP dat device on WinNT 4.0 reads 'tape is write protected' when trying to archive stuff on a new tape which is not protected. Has anyone have ideas on how to overcome this?

The dat tape device is not responding (external scsi device on sgi impact). Does anyone have any simple hints on how to reactivate it? Thank you in advance!

I wish to calculate the time it takes for steel bars (2 types, 4140 steel and EN30B steel) to crack in a spray quenching tank. Because only the sides of the bar is sprayed, cracking occurs at its ends. Can someone give ideas on how I should go about calculating when cracking will occur from the...

Thanks Yakpol, but this does not work on NT.

this does not work on NT thanks anyway, Rich

Please help! I'm getting the following warning message when I launch most applications (MathCAD, IE5, AutoCAD, etc) "The procedure entry point ??_U@YAPAXI@Z could not be located in the DLL MSVCRT.DLL" I need to reinstall MSVCRT.DLL but as its in use by Windows NT it wont let me! CAP...

Please help! I'm getting the following warning message when I launch most applications (MathCAD, IE5, AutoCAD, etc) "The procedure entry point ??_U@YAPAXI@Z could not be located in the DLL MSVCRT.DLL" I need to reinstall MSVCRT.DLL but as its in use by Windows NT it wont let me! CAP...

I'm using Windows NT4 With this system I cant seem to boot up in DOS mode. I'll try registering the file using the regsvr32 command. Thanks for your help

I'm getting the following error message: The procedure entry point ??_U@YAPAXI@Z could not be located in the DLL MSVCRT.DLL I need to reinstall MSVCRT.DLL but its in use by Windows NT and wont let me! CAP GEMINI ERNEST & YOUNG COULD NOT SOLVE THIS PROCEDURE!!! ANY TAKERS??

thanks both Reaver and Butelja Daveo

I'm trying to find the length of a polyline? thanx in advance kind regards, daveo

Hi Roxana, I'm presently trying to simulate a quench cracking problem of steel. Since I know little on the subject, below are some sites I came across that gave me some lead. Some of the terminology may help during searches: Unfortunately, I dont think theres a specific reference to water air...