So here is a more zoomed out picture. The lavender piece on the left is grounded with some CBUSHs and the grey piece is being loaded by those RBE2s. I am interested in the overall stiffness/deflection of the design, the bolt loads between the brown & lavender piece and some stresses in the...
what loads are coming across the joint ? hopefully not fastener torsion ?
The loads across the joint should be mostly perpendicular to the axis of the shaft. There is no torsion in the shaft.
when the joint is fully tight, will the gap in the joint close up ?
is the radius of the hole slightly...
I am working on modeling an assembly where a shaft is held with a bolted split clamp.
I not sure what is the best way to simplify this connection in the FE model.
I currently have the parts set as bonded together, but I feel like that's not quite right. I am thinking instead of putting a...
I am looking to add my company logo to the model of a part.
Ideally, I'd like to draw a sketch of the logo and extrude it.
Unfortunately, none of the text is in a standard font. Therefore the "Text" sketch feature is of little use.
So far the best method I can come up with is to add a Sketch...
