MOSTAFA86
Look at your pump curve. How much power did it require when it was operating correctly? Using the curve how much power would it require at the maximum flow rate plotted on the curve? This will tell you if the power should go up or down with a tubing leak.
Below are general...
MOSTAFA86
zdas04 is absolutely correct about gas and that is likely 90% of your problem.
You stated a FVF OF 1.15 SCF/BBL. I would guess that is oil only. Do you have the water volume factor? Are the volume factors a calculation made from a correlation or an actual PVT test?
To further...
1gibson
There is a change in slip. Most submersible motors in the petroleum industry operate between 3450 and 3500 RPM (two pole) at 60 Hertz full load. Slip for a typical TEFC induction motor includes windage drag which is usually a minimum value. For a submersible motor, filled with...
1gibson
That is an over simplified question to a very complex problem. I will try to give you a generalized answer without writing a book. Submersible motor basics:
1. Submersible induction motors used in the petroleum industry typically range from 1 kV to 4 kV nameplate volts at 60 Hertz...
MOSTAFA86
It usually doesn’t make much difference, so I would suggest using nameplate amps. If you look at a volt loss chart you will find it will only be 1 to 2 percent difference unless you have a very lightly loaded motor.
If you have a lightly loaded motor, say a 100 HP motor with a 50 HP...
For what it's worth I have 81 rows of inputs on sheet 1. There are another 10 sheets performing dynamic calculations based on the 100+ inputs on sheet 1. The worst calculation sheet (named friction) starts on cell A1 and ends on cell EK310. Through the calculations I must predict rotating...
All,
This is what I have and it is working:
Private Sub Worksheet_Calculate()
Application.EnableEvents = False
Call Speed
Application.EnableEvents = True
End Sub
All,
I need to run a macro anytime a cell value changes, but the cell is a formula, not just a static value. I have tried the following code and it works fine if I manually enter a value in the target cell, but if I use a formula in the target cell it does not work. Is there a way to run the...
ahendawy85
In general the statement is true for ESP’s. This statement assumes the underlaod has been properly set. At 0 flow (Closed Valve) the power required will be minimal. The motor seal assembly, intake, pump and induction motor all have losses when operating at very low flows and...
Artisi,
I believe PUMPDESIGNER was Richard Neff. He was killed in an automobile accident near Ft. Lauderdale Fla. A very nice and knowledgeable person.
http://www.irrigationcraft.com/
D23
