JArcuri,
We had a company called Advanced Vehicle Engineer (AVE) help us with sort of thing. They use a white light camera set-up. We had them scan full size body sides.
I know they have scanned whole cars for some NASCAR teams as well as for the Big 3. I also know they have done this exact...
The layering Standard at GM is:
1 - Solid, Part
2 - Wireframe, Part
3 - Centerline, Part
4 - Theoretical
5 - Section
6 - Developmental
7 - Mate
8 - Criteria
253, 254 - Drawing Format & Annotation
Categories:
SOLID: Solids and sheet bodies required to define the part.
WIREFRAME: Lines and...
Ok, so I tried the simple route. I cut apart a cheap Y-spliter for headphones and wired the female jacks to a RJ-11 jack. I unplug the handset (receiver) and it's plug is smaller than an RJ-11 but the clip geometry is the same and the pins line up. So after a bit of trial and error I figured out...
I thinking of piecing together of quick adaptor so that I able to plug my stereo headphones in place of my phones handset. I wondering if it is just as easy as buying a RJ-11, stereo plugs and wiring the right connectors together? I’m wondering if there will be an impedance problem or if I’ll...
Here is my view of the GRIP, UFUNC/API, Knowledge Fusion tools
GRIP:
Ben said BASIC-like, I would say more FORTRAN-like, but that is just semantics. GRIP is good for automating simple, strait forward tasks. A rule of thumb would be if you can draw a flow chart on a single piece of paper...
I remember using a unite in a GRIP function for a program I wrote back about nine versions ago and it worked fine. It model a bent bar using cylinders and spheres. Now, I'd use the Tube
function but that was not around at time. Anyway, a quick look at GRIP Manual shows the Command...
Thanks for the help. The view sectioning will do the job for now but I'd still like be to do more then one section at a time like with section curve.
I knew that view sectioning could create curves but I thought that it would just used the section curve function has the icon is the same...
Hello,
I'm using the Section Curve function to cut sections thru a number of bodies in an assembly. I like for the resulting curves to be the same color as the body it is a section of.
Is there some setting the I can't seem to find or tip to do this?
I could write a GRIP program to cycle thru...
