Recent content by CAD2015

I understand you very well. I had the same reaction....

Mmaulin, Yes, your reply solved the problem. The sketch had and extra curve, overlayed on another. Thanks a lot! (y) :):):) I am laughing of myself: how could I have done such a thing?!!!!!...............

I am getting closer....... There are TWO solids, I have no idea how that has happened. Below is a picture showing the two solids (I gave the different colors, for evidence and place them in "Show" and the other in "Hide"... I do not know why the Extrude (2) has two solids! Creating a...

Yes, it's strange......

Thanks, Cowski. I had the same initial thought before; I double checked, I chosen to subtract.

Hi, This is a very simple operation and never had this problem. I created a tube using extrusion of a sketch circle: The subtract tool doesn't perform. There is just a shadow of the operation, without cutting. Where am I wrong? Thank you!

Toost: Now, I fully agree with you! Thanks!

Great, thanks a lot Cowski! :)(y)

I did use the "command finder " (along with CTRL+1, too) so far. I got it. I was wondering where should be placed & found (for instance) the "Pattern Geometry" tool. (I am assuming that under "Home" tab, don't you think? Thanks a lot!

Hi, How could I locate the location of a tool? In the attached picture, I want to run the pattern geometry: Where could I find it (among the highlighted area), other than clicking on the Ctrl+1 (Customize)?.. Thank you,

Hi Toost, Thanks for your inquire. Yes, I am trying to learn methods to apply on real model.

For some reasons, the associativity on my NX is by default inactive. But is it don't matter; I just wanted to know the fact. Thank you so much!

mmauldin: How would break(disconnect) the link between the grey model and the yellow one?

Great, thanks a lot! :)

mmauldin, Thanks for your reply. Make me a favor and send me a video/movie of your model. It looks very interesting, and I do not want to lose your lesson. (I do not think that the administrator would accept NX file sharing....) Thanks a lot! :)