The key to this is to measure propogation time to 3ns or better and about the only practical way of doing this
is by using a carrier modulated by a pseudo random sequence (which as VisiGoth points out results in a spread spectrum signal). Eg a 10 bit PRS at a 5MHz chip rate will do it provided...
Have a look at Digikey and search for "Non-Fraying Expandable Braid Sleeving". This is very similar to a product used successfully on military aircraft harness design. The harnesses are then clamped using rubber or PTFE lined P-Clamps as frequently as needed to keep them from chaffing, but at...
The VLF antennas in Australia are higher than 100m though, like 300-400m plus an array of surrounding masts to carry the huge top-hat. Quite a few tons of buried copper too to improve ground resistance. Is this one in the photo a broad-band HF antenna. I cannot tell if the guys are active or...
RPstress, I would have thought there was no problem with Cu-Be as long as the Be content was no more than 2% where it will remain in a stable alloy even if abraded.
An isolated ground system is an extension of the 2 or 4-wire power systems we have used on some military aircraft to eliminate airframe currents. It sounds like a good idea but there will still be capacitively induced transient and ripple related ground currents so insulation from ground...
If the battery is going flat so fast with the ignition off then it implies a fault in a permanently connected load.
Burglar alarm, alternator or starter motor for a start. If you can measure the static load current which should be a few mA if there is a burglar alarm connected then try...
This was a simple design and I replaced the top section to select a second band. I could have used in-line tuned traps by resonating some sections of the continuous winding and achieved multiband that way but that's not how I did it.
I chose to wind the common base section as loosely as...
You certainly have your work cut out for you here. Lightning prefers to strike edges like bluffs so it is a risky position.
Do provide the lowest resistance ground possible so if the soil allows it then drive a series of (eg)3 ground stakes as deep into the ground as possible. (A depth of...
smalldriver, if you are going to measure lead resistance then using an ohmmeter is unlikely to give useful results. If possible measure voltage drop while a certain current is flowing from the battery. Sounds the same but doing it this way eliminates a lot of variables and covers the...
I am not sure why you would want to use +/- 270VDC compared to +270V. What advantage would you get?
The purpose of using 270VDC is that it is easily obtained by rectifying a standard 3 phase alternator and it does not require speed regulation to maintain 400Hz. The cabling is lighter and...
I built my first normal mode multi-band helical in 1970 and they were in comercial use then. I can recall examples from around 1967 onwards. My antenna used fishing rod blanks with a standard base section and replaceable tops. The base section was wound with very heavy wire as it carried most...
This is an everyday task and if you are not sure what relay/contactor to use then seek advice from your electrical supplier. If transients are a problem fit a snubber or MOV across the load.
Choosing a relay is straight forward provided you understand what the load reactance is. Study the manufacturers data which will typically show that relays rated at 10A for resistive will only be rated at 3A for inductive loads and 3-4A for capacitive. Loads made up of incandescant globes have...
