From either a part or a drawing, is there a way to
export all of the dimensions (and tolerances) into an
excel spreadsheet or other document?
This would reduce errors from re-typing all inspection
dimensions to a table.
One method I've thought of is too time consuming.
I create a 2nd...
The "key" symbol is correct and a good tip.
Where I work they want to use a note like the following:
4. DIMENSIONS DENOTED BY REQUIRE CALIBRATION
In this note, the " "(blank area) is where I would
drag a dimension (without text and without dimension or
extension lines) and change...
Open your assembly, go to the part in question. It should
say (Excluded from BOM) after the name.
Right click- select Properties, and uncheck "exclude from
Bill of material"
I need to add the inspection dimension symbol to
my notes on a regular basis. Currently, I make a
mock dimension, change it to an inspection dim, and drag
it "behind" my notes until it lines up with where
I want it. I know how to add many types of symbols using
the "add symbol" in SolidWorks...
<hw-threaddesc>-2B<HOLE-DEPTH><hw-threaddepth>
1/4-20UNC-2B'.2
I see you can change the precision of <hw-threaddepth>
by right clicking the hole callout, properties, precision,
and changing the primary dimension setting to ".1".
Where can I permanently set this precision without changing
the...
Hello,
I'm editing the calloutformat.txt file to match our
company's standards. I would like to change
<hw-depth> and <hw-threaddepth> so they display only
one decimal place rather than 3. Is there a file or
setting to change this?
Thanks.
I am considering the purchase of a new computer and would
like to know if anyone has tried running Microstation 95 on
a Windows XP operating system. Or Windows 2000? thanks
