Recent content by bluecomp

Hi, anyone knows good sites with information or videos on high speed five-axis milling and drilling of composite component and molds. Thanks

Hello BigJim85, you can tried: http://www.ajorgelima.com/

Thanks, B.E., is not a single plate in fact, but one large geometry in form of U. The sides of the U geometry are smaller than de central geometry, and they will take a steel plate assembled with fasteners. Over these steel plates will be fixed one strutural mechanism. The composite must resist...

Hello, I would like to laminate a plate with 10 to 12mm tickness, using rovimat, mat and coremat. Anyone can tell me the appropriate quantity and g/m2 of the materials above mentioned. I will use epoxy resin, the hand lay-up process and a vacuum bag. Thanks,

Have you already tried http://www.vesconite.com/

You could buy also in www.bookdepository.co.uk, cheaper and unpaid postage: http://www.bookdepository.co.uk/book/9781560327127/Mechanics-of-Composite-Materials

Hi glass99, I have a small draft report that I can share with you, maybe might help.http://files.engineering.com/getfile.aspx?folder=143ab706-0053-4166-a5a7-890e4189af8b&file=BIOCOMPOSITES_DRAFT_REPORT.pdf

You can try www.bioresin.com.au they have very good green resins.

Hi glass99, I have many books, all purchased in bookdepository, you will not pay delivery, see the sites below, I will send you later more information. I have also a portuguese pdf book, are you interested of him? About architecture, I have at home a french book, but I dont remember the name, I...

Ok guys, thanks at all, after tests I will forward you the final results

Hi guys, I need to produce a cheap mold to inject pu foam in order to obtain prototypes of foam to seat, anyone knows if the mold could be in ABS material. Thanks,

I think that, with the filament winding you can find some problems in the threaded area, and the external surface will not be well accurate. Try to look these sites and contact them. http://www.carbonmods.com/ http://www.hobbycity.com/hobbyking/store/uh_index.asp http://www.dragonplate.com/

Hi JIM508, how goes your work, have you found a solution?

Hello, Depends on the mold, but you can tried to put the mold in a stove and heat it at about 50ºC, removing and work with adequated glooves, or heat localy with a dryer.

Hello berkshire, Is true, I got a fuzzy edge, but I do not know what is the brand new vixen file, can you please send me an image. Thanks for your tip.